How to Install a Car Battery

Putting in a car battery might seem simple, so if you’re rolling up your sleeves to get this task done in Fayetteville, there are several steps that you should take to replace the battery properly and safely. First, gather the correct tools, which includes: 

• Wrenches
• Battery cleaning solution
• New battery
• Wire brush
• Pliers
• Anti-corrosion spray
• Wear thick rubber gloves (for protecting your hands) 

Read on to learn more about how to install a car battery from the service centerat Superior Dodge Chrysler Jeep Ram Of Northwest Arkansas! 

Instructions to Putting in a Car Battery 

Start by parking the car. Activate the parking brake and make sure the engine is turned off. Pop the hood and find the battery. Then:

1. Using a wrench, loosen the nut that secures the black cable (negative cable) to the battery. You can find wrenches or pliers that are specifically designed for car batteries.
2. After the nut has been loosened, you can twist and pull the cable off. If the nut is stuck, don’t use a screwdriver or another tool on it; try to loosen it more with the wrench until it gives. If you still can’t get it, try some penetrating oil. 
3. Follow the same steps to remove the red battery cable from the positive terminal. 
4. Loosen then remove the battery hold-down clamp, which keeps the battery from shifting around under the hood. 
5. Now, the battery is ready to be taken out. Remove it carefully using both hands. Keep in mind that the battery is heavy. 
6. Use a baking soda and water mixture or a battery cleaning product to remove corrosion that may have built up in the battery tray or the hold-down clamp. 
7. Then, use a wire brush and cleaning solution to clean off the battery cable connectors. 
8. Place the brand-new battery in the battery tray, then secure it by tightening the hold-down clamp.
9. Spray anti-corrosion solution on the new battery’s positive and negative terminals before connecting. Doing this can help protect the battery and lengthen its life. 
10. Attach the battery cables to the battery terminals. First, connect the red cable, then connect the black cable.
11. Make sure the connections are secure, then try to move the battery. If it doesn’t move at all, it’s good to go! 
12. Start the engine. If the battery has been properly connected, the engine should start right up with no issues. 

Important note: When moving the battery, be extremely careful to avoid spilling battery acid. Battery acid is highly corrosive and can cause chemical burns. 

Need a Car Battery Installation Near Siloam Springs? Come to Superior Dodge Chrysler Jeep Ram Of Northwest Arkansas!

Is the process as easy as you think it is? If not and you’re not up for the challenge, our experienced technicians are in your corner, ready to help you! Bring your car over to our center, which is located near Springdale and Bentonville. We can even give you more tips, such as how to use a car battery charger and how to ensure your car battery will last for as long as possible.